How to install pocket door frame

How to install a single pocket door? How do you build a pocket door? Once the frame is in place, it’s time for the pocket door installation.

Install the track according to the thickness of the header. For doors ¾-inch thick, install the track. You should be able to reconfigure that joint. Installing the pocket door frame first, then attach the wall onto the new pocket door frame.

You do realize you will need to place a header over the top of both the door and the door frame. That could be quite a project,definitely not in concrete, entire section would have to be cut out to fit door and pocket, re frame, sheetrock, etc. Get at least three prices from different contractors. The total rough opening for a 30x pocket door. Then cut the exposed studs to make room for the new framing.

Next, install the slider track using the rails that came in your pocket door kit. Be sure to screw the brackets into the studs! Then put the hardware and door into the slider track.

Before you start framing a wall to accept a pocket door you’ll need to choose a pocket door frame. We like the pocket door frames that Johnson Hardware sells. Each manufacturer is slightly different so it’s best to look up the specification or buy the frame before you frame the wall. This post contains affiliate links. Learn more and read our full disclosure policy here.

We chose to keep the pocket door installation as easy as possible, by using a pre-made pocket door frame and reusing the old door from the bathroom. I’m using a pocket door kit from Johnson Hardware for a 36″ door. These kits make installing a pocket door.

Stud Pack 52views. Attach the door frame to a stud and to the header. Use shims and check that the frame is kept square, level, and plumb. If you are installing a set of two doors , install another frame on the other side. The first step in selecting a pocket door is making sure you have sufficient room to install the pocket door.

Pocket Door Rough Opening. A pocket door needs a cavity in the wall large enough to store the door when it’s open. As you can see in the diagram the door is hung from a track system on the top and the door slides into the “pocket” or cavity to the side of the door opening.

If there is an existing door , remove it and. This makes a room more versatile, since it can be closed off from the rest of the house when necessary. X Research source This is a great way to maximize your living space, and with a lot of patience and a little bit of know-how, it is a home-improvement goal. Step 4: Mount the pocket door.

Measuring up from the bottom of the door , fasten the bumper on its back edge halfway up—for a standard door. For a traditional 32-inch-wide interior door , you’ll need at least. Cut through the nails to remove the door and jamb assembly.

Use a reciprocating saw and metalcutting. New studs form the side jambs of the opening. Using 2×studs, frame a new rough opening to fit the dimensions for the door jamb indicated by the manufacturer of the pocket-door kit. The unfinished natural wood frame can be installed to either side of the door opening.

Shop pocket door frames and a variety of hardware products online at Lowes.