Aniline dye wood

What are the uses of aniline? How to apply wood dye? Moser water-soluble aniline dyes used here come in more than six dozen colors from wood tones to bright primary shades and cost around $to $per ounce (which makes a quart of liquid dye ). For use, stir the dye powder into hot water, as shown below. Applying Aniline Dye to Wood.

Mixing Dye Powder : Dissolve the powder into very warm distilled water. The same ratio holds for solvent mixing. Mix the components and allow to sit for a few hours to settle out any undisolved solids. Dissolve in water to achieve deep penetration with the best light fastness of any of the Anilines.

Add warm water to powder to get the desired color. Colors may need Wood Alcohol to achieve color. ANILINE DYE Water Soluble. They will not leave a muddy surface.

They can however raise the grain and create a fuzzy look. Water-soluble aniline dye is a deep penetrating stain with the best light-fastness of all our anilines. Available in 1-, 4- and oz.

As a result, dye travels wherever the solvent travels, and that’s deeper into the wood than stains. That adds depth to your finish. Aniline dye is the best method I’ve found to add color to my furniture without camouflaging the surface. Extremely easy to apply to achieve DEEP rich even color. You can mix this stuff with water or alcohol and it dries very quickly.

I then top coat it with a brush on lacquer. Homestead Transfast Dye Powder , Light Oak. Alumilite Dye 1oz Yellow. Wherever the solvent soaks into the wood fibers, it takes the dye with it, changing the color of the wood cells themselves. This produces a noticeably different look than pigments, especially on dense, tight-grained woods, such as maple, that offer few places for pigment to settle.

Dyes , Dark Mission Brown. If you want to apply an aniline stain to the wood and then brush or rub over it with a finish, you need to use a finish that is incompatible with the type of stain you are using and then remove ALL the powder that is left on the surface after the carrier dries. Our water-soluble aniline water stains are made from aniline dyes. Unlike pigmented stains, these do not mask the natural grain and texture of the wood.

They are inexpensive and easy to blend. They penetrate well and can be used under any type of finish. BEST ANSWER: Try experimenting on a small quantity of product by reducing the dye with water and add to a sample of the water based varnish. Your best bet is to use the dye as described on the label, apply it to unfinished wood , then seal it with Arm-R-Seal or unwaxed shellac then, clear coat.

Unlike many catalogs, we do not buy bulk pre-mixed colors and repackage them. These are top quality dyes! Water-soluble dyes are your first choice—The most commonly available dyes are powders dissolved in water.

Using a pad made from an old cotton t-shirt, dampen the wood with a little water, then apply the dark brown dye. Usage Add boiling water to a suitable container (we recommend glass or HDPE) and stir Gradually add dye and continue stirring until it is all dissolved Leave to cool to room temperature We recommend straining before use to remove any undissolved clumps of dye Dye can be applied by sponge, cloth,. The water keeps the dye from going on too strong.

By the end of the century, they were used in factories to color wood.