Its revolutionary torque-reduction channel traps dust where it can’t obstruct the thread action, drastically reducing binding, stripping or snapping. It is designed to help resist uplift forces and has double shear staggered nailing for lateral resistance. Straps are designed to transfer tension loads in a variety of applications and are available in a wide variety of sizes and load values.
These ties connect both solid-sawn and engineered lumber across a wide range of applications. H10S can have the stud offset a maximum of from the rafter (center to center) for a reduced uplift of 8lb. H10S nails to plates are optional for uplift but required for lateral loads.
From framing angles to straps to heavy-duty girder hangers, we offer the most diverse product line so that you have the right product for the job. Loads are based on attachment of cold-formed steel members having a minimum thickness of mil (ga.). Hurricane ties are shown installed on the outside of wall for clarity.
Installation inside of wall is acceptable. For Continuous Load Path, connections in the same area must be on same side of wall. Galvanized to resist corrosion. Easier and stronger than toenailing or screw fastening.
Joist hangers are designed to provide support underneath the joist, rafter or beam to provide a strong a connection. The RR provides a connection between a rafter and the ridge of a roof. FREE Shipping Get free shipping Free 5-day. The hurricane tie series features various configurations of wind and seismic ties for trusses and rafters. I noticed that steel cables has been hidden behind the rafter ties to try to reinforce them, but the screws attaching the cables to the rafters were also pulling out.
This also was a sign of tremendous tension. Strong-drive sd screws. The high quality and innovative design tightly secures rafters to the gazebo, which makes the structure safe and strong.
The fastener system negates the possibility of the gazebo being blown over by high winds. These plates are designed for non-structural applications and are not load rated. Tie Plates come in two styles. The bolts shown are not typically the way a conventional residential roof would be framed.
The roof framing mock-up below shows a standard rafter tie. Ships from and sold by Factory Direct Supply WPB. Its simple design makes installation intuitive and quick, resulting in lower labor costs. Adjustable from 0° to 85°, you can bend the TJC to the desired position (one bend cycle only).
Rafter tie Trusses rafter ties. Each TJC is shipped with 67. Nail hole locations allow for easy installation. No bevel cut is required. SD screws can be used to increase standard load values.
Free 2-day Shipping On Millions of Items. A typical H2A installation ties the rafter to the stud while spanning a top plate. Jan This Pin was discovered by Jeff Boyles. Simpson H11Z Hurricane Tie - Zmax Finish. Sign in to.
If using the latter, make sure the width of the truss or rafter is suitable for the width of the opening in the hurricane tie. Shop joist hangers and a variety of hardware products online at Lowes.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.