How to fill drywall holes

How to patch large holes in drywall? How do I cover large gaps in drywall? What is the best way to repair holes in drywall?

Apply the First Pass Holding the knife at an angle to the drywall with the mudded side facing the wall, press the front edge of the knife against the wall and draw it across the hole. The flexible knife blade should bend slightly as you draw the knife. Check to make sure the hole is filled flat with joint compound.

Run strips of self-adhesive fiberglass drywall tape around the patch, centering the tape on the seams. Use a 6-inch drywall taping knife to spread drywall joint compound across the patch and tape to create a smooth, flat surface. Let the compound dry overnight, and then sand until smooth. Repeat with a second coat. The first coat will shrink a bit, leaving a slightly smaller dent to be filled by the second coat.

Sand lightly to blend with the surrounding wall. A small quart size container of drywall mud would work or a yogurt size container of lightweight patching compound. Both can be found at stores like Home Lowes, Walmart. Durhams Water Putty works well and it gets a lot harder than the drywall itself, or standard drywall joint compound for that matter.

I show some easy tips to fix drywall. If you have small nail holes , almost any type of. Step 1: Take the Drywall taping knife and scrape away any part of the hole that is not flush with the wall.

You want to make it so when you run your hand over the hole it is perfectly flush with the wall. Then cut the hole with a drywall saw (Photo 3). It’s best to slightly angle the saw so the opening in the back is larger than in the front. That way the box will slip into the opening easier.

If you cut along the outside of the lines, the box should fit. But don’t assume the holes will slip perfectly over the boxes. Fill the crack with new drywall compound and apply a thin coat of compound to the wall surface where the old tape was removed.

While the compound is still wet, place a strip of fiberglass tape over the seam bridging the gap between the ends of the existing tape (Image 4). Grab a small glob of spackle that is just larger than the hole you want to fill. Fixing holes in drywall is a common part of maintaining walls. Place the patch over the hole and pencil its outline on the damaged wall.

The challenge of patching holes in drywall is in covering the gap. Joint compound is fine for filling cracks, but won’t work for small holes bigger than a quarter. Fix tiny nail and screw holes : Tiny nail and screw holes are the easiest to fix. Use a putty knife to fill them with spackling or wall joint compound. Allow the area to dry, then sand lightly.

Anything larger must be covered with a bridging material for strength before patching compound can be applied. Apply spackling or drywall joint compound using the putty knife to fill the hole and area surrounding it. Place a piece of paper or mesh drywall joint tape over the hole and wipe flat using the. Let it cure fully, and fill any dips if required.

Once the above has been done, drill another hole into the center, insert an anchor that can distribute the load behind the drywall , and reinsert the screw.