How to patch a large hole in the wall

How do you patch a large hole in drywall? How should I patch a large hole in brick? In a small bowl, mix parts joint compound and part water.

Dip a stiff brush into the mixture and hold it close to the wall , bristles up. Once dry, sand the patched area down until the finish is smooth with the surrounding. The first coat will shrink a bit, leaving a slightly smaller dent to be filled by the second coat.

Sand lightly to blend with the surrounding wall. It depends on how big the hole is. Poke a hole in the center of. If the holes are smaller than inches across, you can buy a patch kit that has a grating for the mud to attach to. If the large holes are much larger then I would just replace the by 2. If you do it this way make sure you.

The ONLY quick, cheap fix is HIDING it. A REAL repair depends on the size. Must home improvement stores have drywall patch kits. Cut larger holes into a square or rectangle, then create a patch out of drywall and attach it to the inside of the hole.

Cover up either type of patch with joint compound and sand it to blend it into the surrounding wall. Cut a piece of fiberglass mesh so that it fills the entire surface of the hole. Place the mesh into the. Allow the spackling paste to dry and then paint the patch , if necessary.

Or, rather, one very large thing: a huge hole in the cement wall that separates our garage from our basement. How to Fix a Hole in the Wall. Step 2: Prepare the Hole. Gather your materials. Push the cardboard through the wall hole keeping the string ends facing you and ensuring that all corners sit behind intact drywall.

Pull the strings tight to hold the cardboard in place. Using a utility knife, Tom cuts a square piece of drywall larger than the hole he needs to patch. He then traces that piece over the hole and cuts the outline on the wall using a jab saw. Remove loose material from the hole in the wall by probing it with the tip of a. I used a soaked sponge to wet the bricks and mortar, making it easier for the cement to get a good bond. To apply the cement, I grabbed a good handful, and worked it into the right shape, breaking up any clumps.

Tape the printer paper over the hole and apply a thin layer of joint compound over the surface of the paper and at least inches beyond the edge of the paper on all four sides. You may also need to add texture to match the wall before painting over your repair. For larger holes, you will need to replace the missing wall material, be it plaster or wood. Any of these devices will help you smooth out the edges so they can butt up neatly to your patching materials.

Patching Large Holes. To patch a larger hole, you will need something to hold the spackle in place while it dries. The easiest way is to buy a wall patch kit.

I used this mesh patch because I already have spackle and a putty knife, but this wall patch kit comes with everything you need. Measure the width and height of the hole. Cut a rectangular patch about a half-inch larger than the hole in both dimensions. Center the patch over the hole and trace it’s shape onto the wall.

Score the lines with a utility knife, then use a wallboard saw to cut from the hole to each corner of the scored rectangle. Start by placing the patch over the hole to determine the size of the patch. Once the patch has been cut, take off the backing paper and install the patch over the hole. Turn the drywall to the back and hold it against the wall partially covering the hole. Mount a board to the studs on either side of the hole.

Then use this board to mount your wall material patch. It should fit snugly, but small gaps around the edges are fine. Then stick the patch over the hole and cover it with two or three thin layers of joint compound.

You can speed up the process by using setting-type compound for the first coat.