How to build pocket doors

How to install a single pocket door? The door does look great, you did do a great job on the installation and it was neat to see the process and the great color choice and the surroundings on your side look nice, but from the other side, the single door in the long wall doesn’t look goo I would have done as they did in times bygone and installed a double, center opening pocket door setup, this. Since you are building the wall, get the door kit first and set it where you like and then frame to its location per instructions.

I simple door will cost about a fourth what it will cost for a pocket door. Reason why, with a pocket door, you have to have the door framed twice as wide as the door so the door can hide inside it. Glue and screw together the 2-by-4s to build a pony wall (a smaller, non-load-bearing wall) for hanging the track for the pocket doors.

Make sure the frame is level. Standard type pocket door locks are easily installed by cutting a notch in the edge of the door. These style of locks generally (not always) have an integrated finger pull to extract the door when the door is completely in the pocket. These are our most popular type of pocket door lock. Look for switches or electric.

Replace the existing header. Use a reciprocating. Install the header-and-track assembly on the top jamb with the fasteners and brackets supplied with the door. Nail the end plate to the wall studs. Check that the track is level so that the door rolls easily.

Apply wood glue on all top surfaces of the pieces of both your inner and outer frames. Attach the plywood sheet to the back of the door. Flip the door so that the newly attached plywood side faces down. This kit should contain the door , split studs that allow the door to retract into the wall, a track on which the door runs into the wall, and door hardware.

Most are under $100. You may be able to find pocket doors at lumberyards, too. Pocket doors are a great way to economize on tight space. By sliding against the wall, the door opens up flow in a room but can still be closed off for privacy.

Find the right pocket door hardware, then follow these simple steps to create your own pocket door frame system. Step 4: Mount the pocket door. Measuring up from the bottom of the door , fasten the bumper on its back edge halfway up—for a standard door.

Building a pocket door is a great alternative when you don’t have enough room in your home for a door that swings. A pocket door is built to slide away into the wall, and there are a few precautions you need to take before you take on a project like this one. Be sure to purchase a high-quality pocket door frame with durable hardware. Additionally, the size of the header increases with the weight of the door , so be sure to factor this in.

Tools and Materials: Miter Saw. Kreg Jig for Pocket Hole Screws. Sliding Door Hardware.

POCKET DOORS : Give any room more space with pocket doors ! Traditional swinging doors take up valuable floor and wall space. Some of this will be attached to the door and some will be attached to the wall. Follow the instructions that came with the pocket door kit.