How to change a dryer cord? Double-check that the dryer is in the “Off” position. Plug the new dryer cord into the outlet. How do you replace a dryer cord? Turn the dryer to the “On” position to test operation.
Make sure the dryer is unplugged from the electrical source, then remove. Remove the Strain-Relief Fitting. Install the 3-Prong Cord. Disconnect it from there and reconnect it under the.
Reattach the connection box cover plate with its screw(s). Tomahawk DIY 568views. Locate the white machine wire that is now connected to the neutral, or center, screw terminal. Slide the dryer into place, and reconnect the dryer vent duct, if necessary.
Dryers require a special dryer outlet to function properly. This outlet is designed to provide the dryer with both a 240V and 110V electricity supply. Insert the loose end of the 3-prong cord through the installation hole found in the electrical connection access box. Always remember safety is the number one thing.
The terminal block will have three lugs with nuts or screws holding the cord’s conductor wires in. The wiring just above the plug can get damaged when you insert or take the plug out of wall sockets. Cut off the cord about inches above the plug.
Squeeze the two prongs of the new plug together (like you squeeze tweezers) so you can pull them out of the casing. By cutting the cord shorter, you avoid potential trouble spots. PLEASE ALWAYS BE SAFE! Older three-prong outlets lack the roun ground wire opening. I AM NOT LIABLE FOR YOUR ACTIONS WHEN WORKING WITH ELECTRICITY.
Retrofitting a dryer outlet is a job for an electrician. In most areas, these no longer comply with the National. The green ground wire in the cord is not even connected to the dryer. Check with your local code enforcement agency for legal requirements before performing any electrical repairs.
If you install a new dryer in an older home or an old dryer in a newer home, you may find that the cord on your dryer does not fit the outlet on the wall. While they can both effectively power a traditional dryer , the 4-prong model contains an extra grounding wire as a preventive measure. The Red and Black leads are the hot wires with 220-volts between them.
The White lead is the Grounded neutral conductor and there are 110-volts between it and either of the hot legs. Unplug the dryer and move it out from the wall. Some have small machine screws with. All this background is nice but our homeowner still needs to know what to do.
There are two options for correcting this to get the dryer going. Trace the dryer cord to where it enters the dryer housing. Replace the cord and plug for the dryer to match the outlet in the wall. Grounding reduces the risk of electrical shock by redirecting an electrical current away from the appliance in the event of an electricity surge.
Importance of Grounding a Dryer You must properly ground a dryer.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.