How to patch a hole in the ceiling

How do you patch a large hole in drywall? How to quickly patch a hole in the wall? Locate and Measure the Hole. First, locate the existing framing that supported the old electrical box. This will be the mounting point for the filler piece of wood to which the drywall patch will be secured.

Measure the depth and diameter of the existing hole to determine size of filler piece. Go to Home Depot in the drywall section they have drywall patches in different sizes. They go on very easy and the instructions are on the package. You don t need to put anything else behind it, but you will need a small bucket of drywall. Lowes will cut it for you.

It is light so one person can holed it up use screws to screw in to the wooden beams. That should help but you can. If it is drywall, easy and cheap way. Get a piece of cardboar bigger than the hole.

Run string thur the center (dental floss works also) and back down about one inch over. Get some drywall Spackle, spread around the inside of hole, push. Put on safety goggles and a dust mask.

Protect your eyes and mouth with safety goggles and a dust mask. Patch a small hole in the ceiling with several strips of drywall tape. Method of 3: Spackling and Sanding. Just cut a bunch of strips long enough to cover the hole and have a few inches of left over tape on each side, and apply them over the ceiling hole until it is covered up completely. Then patch over the fiberglass with drywall joint patch compound.

Screw backer boards above the unsupported drywall ends of the enlarged hole and install the new patch (Photo 2). Mist water over the surrounding ceiling texture in an area about in. Then tape, mud and skim-coat the entire patch. This layer will not be perfect, but it should cover the tape and fill the space between the patch and the ceiling.

Avoid overworking the compound. Let the patch dry overnight. In this instance the hole was made specifically to insert a timber for screwing a new light fitting onto.

The same method would be used to mend a hole. Widen the hole until you have found the next joist and cut the existing ceiling off square to it and in the centre of it. Now screw (do not nail) the existing ceiling to that joist. Place a drop cloth beneath the work area, put on safety glasses, then use a utility knife to make a. Spread a layer of putty across the hole and push it into the hole , using a putty knife and smoothing. This drywall repair process requires the use of added wood framing to hold the new patch in place.

To repair smaller wall holes of several inches in both drywall and plaster without adding framing, try the repair process at this link. Check the bottom of this page for a video of this wall and ceiling repair technique. After cutting the patch to the same. Repairing a Smooth-Surface Ceiling 1. If possible, check the space in the attic above the damaged area for wires or plumbing lines. Poke an awl through the ceiling around the damaged area to determine how far the damage extends.

Step 1: Cut out the patch Photo by David Carmack Find a scrap of drywall that's the same thickness as the damaged drywall, and cut out a square-cornered patch big enough to cover the hole. Use a stud sensor to. Place the patch over the hole and pencil its outline on the damaged wall. If a drywall ceiling in your home has developed a crack, you can fix it relatively easily.

Begin by laying down plastic and scraping away any loose paper or debris from the drywall, and then apply a single piece. Spread a plastic drop-cloth over the floor beneath the dripping or water damaged area. Place a bucket below the damaged area of the ceiling or where dripping is occurring.

If there is active dripping,.